Rod Holders & Backing Plates for Bluefin Tuna

The Main Sand Box for bertram31.com

Moderators: CaptPatrick, mike ohlstein, Bruce

Post Reply
moguls2go
Senior Member
Posts: 189
Joined: Jan 31st, '10, 19:44
Location: Portsmouth, NH

Rod Holders & Backing Plates for Bluefin Tuna

Post by moguls2go »

For those of you targeting larger fish, what have you done in terms of gunwale modification/reinforcement? I stuck a few bent butt rods into our existing rod holders and am a little freaked out by how much the gunwale is flexing when I push on the rod. The amount of pressure a fish applies is going to be much stronger.

I bought a swivel rod holder with a backing plate that I plan to install in the next day or two; the backing plate is only about the size of the rod holder plate on top thought.

Is additional fiberglass reinforcement something you've done before applying that kind of pressure?
Max
User avatar
ktm_2000
Posts: 1000
Joined: Jul 17th, '18, 14:46
Location: Central Mass

Re: Rod Holders & Backing Plates for Bluefin Tuna

Post by ktm_2000 »

I haven't put them to test but here's what I've got, 30 degree forward angled out, 15 aft, 0 degree swivels on transom all lees HD with the deeper mount
https://photos.app.goo.gl/zrF8U5KwyR2XMzp86

I fitted and epoxy'd in 3/4" Marine ply under the top cap, and will be through bolted - here's a core cut out pic
https://photos.app.goo.gl/BfKpJaUNffGpjMzy8
moguls2go
Senior Member
Posts: 189
Joined: Jan 31st, '10, 19:44
Location: Portsmouth, NH

Re: Rod Holders & Backing Plates for Bluefin Tuna

Post by moguls2go »

That makes sense. How big is the piece of plywood underneath?
Max
User avatar
ktm_2000
Posts: 1000
Joined: Jul 17th, '18, 14:46
Location: Central Mass

Re: Rod Holders & Backing Plates for Bluefin Tuna

Post by ktm_2000 »

the backing pieces fully fill up under the gunnel, here's a pic of the stern when I was building the motorwell. I don't have pics of the side gunnels but those pieces have a similar setup except that I didn't fill up the raised portion with strips of fiberglass, I just used excess filler.

https://photos.app.goo.gl/ttVwWwqFUjg2BFBg8
Ironworker
Posts: 747
Joined: Jul 22nd, '17, 13:59

Re: Rod Holders & Backing Plates for Bluefin Tuna

Post by Ironworker »

I did something similar except I used 1/2" coosa. I glassed both sides of the coosa then used a layer of glass to laminate it under the gunnel. I'm using stainless backing plates behind all of that.
Rick Ott
Carolina Reaper
Hull # Don't have a clue
Tony Meola
Senior Member
Posts: 7036
Joined: Jun 29th, '06, 21:24
Location: Hillsdale, New Jersey
Contact:

Re: Rod Holders & Backing Plates for Bluefin Tuna

Post by Tony Meola »

I believe Capt. Pat had said that when he reinforced the transom gunnel for rod holders he ran the backing plate from corner to corner.
1975 FBC BERG1467-315
Post Reply

Who is online

Users browsing this forum: Bing [Bot], Google [Bot] and 195 guests