Bottom Paint

The Main Sand Box for bertram31.com

Moderators: CaptPatrick, mike ohlstein, Bruce

Post Reply
User avatar
John F.
Senior Member
Posts: 2114
Joined: Jun 29th, '06, 07:58

Bottom Paint

Post by John F. »

I bought a B20 last year, and I don't know whether it has a hard paint of an ablative on it. Its got a pretty good (bad) build-up on it, and when I scraped some loose stuff today, it seemed softer than a hard paint. What should I use--a hard or ablative? And no bottom job--I want to slap some paint on her and throw her in. I'm used to hard paints.
User avatar
CaptPatrick
Founder/Admin
Posts: 4161
Joined: Jun 7th, '06, 14:25
Location: 834 Scott Dr., LLANO, TX 78643 - 325.248.0809 bertram31@bertram31.com

Post by CaptPatrick »

John,

You can put ablative paint over hard paint, but not hard paint over ablative...

When you rub your bare hand hard on the paint, the hard paint will only leave a trace on your hand, (due to oxidation of the paint in air), but the ablative will readily rub off onto your hand at about ten times the rate.

Br,

Patrick
User avatar
John F.
Senior Member
Posts: 2114
Joined: Jun 29th, '06, 07:58

Post by John F. »

Thanks Captain.
User avatar
gplume
Senior Member
Posts: 455
Joined: Jan 2nd, '07, 21:23
Location: North Scituate, RI

Post by gplume »

Thanks also. Good timing for this post. I am helping my sister in law get her 19 foot center counsul ready, and was not sure on the bottom paint. This answered my question as well.

Any known issues hard to hard (brand to brand compatibility.)? Not sure if I should worry about that.
Giff
User avatar
CaptPatrick
Founder/Admin
Posts: 4161
Joined: Jun 7th, '06, 14:25
Location: 834 Scott Dr., LLANO, TX 78643 - 325.248.0809 bertram31@bertram31.com

Post by CaptPatrick »

Giff,

No problems between brands in terms of compatability...

Br,

Patrick
User avatar
gplume
Senior Member
Posts: 455
Joined: Jan 2nd, '07, 21:23
Location: North Scituate, RI

Post by gplume »

Thanks again.
Giff
User avatar
Mack
Senior Member
Posts: 212
Joined: Jun 30th, '06, 13:28
Location: Annapolis, MD

Post by Mack »

Since we are on the subject of bottom paint, how long do you have to wait for the hull to dry after haul out to start prepping & painting. Obviously temperature an humidity play a part, but what is the general rule of thumb?

What about drying time between the final coat and splash. My boat spent the winter in the water. I was planning to haul it for a long weekend in June or July to do the bottom. I expect not to have to do much prep, though you never know. The goal would be to (hopefully) get the job done over a weekend.
Mack
1973 B31 "MAKO"
scooter28

Post by scooter28 »

I'm not sure about how long to let the hull dry i guess it depends on whether or not u have blisters that will hold extra water. Anyways as far as how long before relaunch it typically depends on what type of paint and what paint manufacturer you use. If you got an idea what you'll be using check out their website/ product info it'll tell u there.
Post Reply

Who is online

Users browsing this forum: No registered users and 49 guests