Got the base down now
Moderators: CaptPatrick, mike ohlstein, Bruce
Got the base down now
Ok we got the hatches cut & the base in.. Not aluminum, Like I said before .. Heres some pics,If you guys arent tired of them by now,,
Hey this is almost as much fun as a repower
Hey this is almost as much fun as a repower
- Brewster Minton
- Senior Member
- Posts: 1795
- Joined: Jun 30th, '06, 07:44
- Location: Hampton Bays NY
- Contact:
- Vince Luciani
- Senior Member
- Posts: 172
- Joined: Jul 1st, '06, 09:50
- Location: Rehoboth Beach, Delaware
Looks good Wayne. Those stone masons do good work. (I should know my crew who are all stone masons helped me with my entire repower).
One question. Will your deck be removable? It looks like its screwed down permanatley and that you will be glassing over the screws? I am debating whether I go this route or not.
Vince
One question. Will your deck be removable? It looks like its screwed down permanatley and that you will be glassing over the screws? I am debating whether I go this route or not.
Vince
- CaptPatrick
- Founder/Admin
- Posts: 4161
- Joined: Jun 7th, '06, 14:25
- Location: 834 Scott Dr., LLANO, TX 78643 - 325.248.0809 bertram31@bertram31.com
Wayne,
Looking real good!
Seeing the blue tape on the hydraulic lines reminds me to offer a masking tip for the future:
When painting, especially in bilges, engine compartments, engines themselves, & other areas where masking involves lots of wiring & hoses, use aluminum foil rather than tape. It's quicker, less expensive & far easier to remove when the job is done. Just crush it on. Save the tape for flat surfaces...
Br,
Patrick
Looking real good!
Seeing the blue tape on the hydraulic lines reminds me to offer a masking tip for the future:
When painting, especially in bilges, engine compartments, engines themselves, & other areas where masking involves lots of wiring & hoses, use aluminum foil rather than tape. It's quicker, less expensive & far easier to remove when the job is done. Just crush it on. Save the tape for flat surfaces...
Br,
Patrick
Whatever is within reach... Hey I need rollerskates for my knees.They're shot after40yrs ,of flat stonework(Now I only take veneer & walls)
Just to keep the record straight,The boatyard guys are ndoin most of this deck, ever since we got above the bilge...
I have seen em use the foil trick too.
Getting closer now.
Good point on the removable middle for the tank, I requested that in the begining...
Wayne
Just to keep the record straight,The boatyard guys are ndoin most of this deck, ever since we got above the bilge...
I have seen em use the foil trick too.
Getting closer now.
Good point on the removable middle for the tank, I requested that in the begining...
Wayne
- Harry Babb
- Senior Member
- Posts: 2354
- Joined: Jun 30th, '06, 21:45
- Location: Fairhope Al
- Contact:
Who is online
Users browsing this forum: No registered users and 224 guests