315 Yanmar ?

JohnCranston · Post by **JohnCranston** » Oct 21st, '07, 16:50

What series Raycor's do I need for these engines?
Thanks in advance.

In Memory of Vicroy · Post by **In Memory of Vicroy** » Oct 21st, '07, 17:42

900s should do fine.

UV

JohnCranston · Post by **JohnCranston** » Oct 21st, '07, 20:23

Thanks UV.

Brewster Minton · Post by **Brewster Minton** » Oct 22nd, '07, 07:01

Make sure they are in a place were you can change them easy. Filters often need to be changed when conditions are poor (3-5 foot seas). I have seen many times where they have been put in in such a way that you cant get at them except a the dock. My 2 cents.

Mikey · Post by **Mikey** » Oct 22nd, '07, 08:26

Amen Brewster, Amen.
Seems I promised pictures of my Racor installation. Did I post those or was I dreaming?

ZeroCavity · Post by **ZeroCavity** » Oct 22nd, '07, 08:46

Reed this article @ BoatDiesel.com

http://boatdiesel.com/index.cfm?&CFApp= ... 3060666437

I did a similar setup.

Rawleigh · Post by **Rawleigh** » Oct 22nd, '07, 14:16

I always thought a manifold system would be great so that you could run both engines off one filter during the filter change thereby enabling you to keep headway into a big sea.

Capt. Mike Holmes · Post by **Capt. Mike Holmes** » Oct 22nd, '07, 17:06

Rawleigh, or just a bypass on each filter. Running without one while changing an element would probably not cause any harm.

bertram31.com

315 Yanmar ?

315 Yanmar ?

By-pass

Who is online