sunk 31 cape cod
Moderators: CaptPatrick, mike ohlstein, Bruce
sunk 31 cape cod
A friend sent me a story from a cape cod news paper about a 31 hitting some rocks and sinking...Boat was The Raven. Skipper was saved by the USCG
-
- Senior Member
- Posts: 73
- Joined: Jun 30th, '06, 06:10
- Location: Cape Cod
That boat was all redone as well. I used to keep my B28 in the river and run in and out of there all the time with the new boat. It gets real shallow at low tide if you stray from the channel for about a mile off the mouth. I am surprised by the sinking as that boat is kept at one of the big houses at the mouth of the river and has been there for several years and the Capt had to know how shallow it gets. Then again as Mark can confirm you see guys cut the channel all the way to the no wake zone.
Jon
Jon
- CaptPatrick
- Founder/Admin
- Posts: 4161
- Joined: Jun 7th, '06, 14:25
- Location: 834 Scott Dr., LLANO, TX 78643 - 325.248.0809 bertram31@bertram31.com
Now, I ask again, how many of you haven't replaced the strut pads in your boat?????
I'd just about put money on "IF" there were replacement strut pads, according to my way of construction, there would have been no sinking... Just a bent wheel & bruised pride.
Does the phrase; "It ain't IF, but WHEN" mean something now? CAUTION! -- Perhaps the weakest structural element on the Classic Bertrams is the strut backing pad. (Boatbuilding Tips and Tricks)
Br,
Patrick
Br,
Patrick
Molon labe
Patrick
Molon labe
- thuddddddd
- Senior Member
- Posts: 1028
- Joined: Jun 29th, '06, 07:42
- Location: N. east Ma, home of fat teddy
Patrick,
thanks for the info -- I went and read the article. It is something I had
not noticed on the site before. My backing plates are under saddle tanks
most likely they are original. Next time I haul I'll plan on doing something about this.
I am getting a little closer on the helm pod. My work schedule has wreaked havoc on my rewire plans this summer but we are back at it now.
regards, Merlin
thanks for the info -- I went and read the article. It is something I had
not noticed on the site before. My backing plates are under saddle tanks
most likely they are original. Next time I haul I'll plan on doing something about this.
I am getting a little closer on the helm pod. My work schedule has wreaked havoc on my rewire plans this summer but we are back at it now.
regards, Merlin
Who is online
Users browsing this forum: Google [Bot] and 117 guests