I have a transmission leak in the back of the tranny-I think it is a rear seal--also have my deck out as I am replacing the tank. How difficult a job is it to replace the seal now that i have good accessability?
Craig,
If you can slide the shaft back to get a socket and ratchet on, you can remove the output flange. You will have to make a tool to hold the flange by the bolt holes.
Replace the seal and the crush sleeve and torque to specs.
I just changed my rear seal, took about 3 hours. Make sure you have enough room when you slide the shaft back . I had to use a socket and pipe wrenches, the ratchet would not fit. Good luck.
what good is a boat if you cant spend all your money and time you dont have working on it.
