I'm hoping the brothers that do electrics professionally (I seem to recall that we have a few of those) can advise me here...
At the time I purchased the new generator I didn't have the boat's electrical schematics, I also knew a lot less about the boat then I know now... When it came time to ship the generator the MASE rep asked me whether I wanted the generator set up as a straight 120 or as a 120/240... The (original) cable running from the electrical panel had 4 wires in it:
- Black 4 gauge wire (presumed to be line 1)
- Black with red stripe 4 gauge wire (presumed to be line 2)
- White 4 gauge wire (presumed to be a common neutral)
- Green 6 gauge wire (presumed to be a common ground)
Yesterday, while waiting for something else I studied the relevant electrical schematic and the actual panel... It took me a while and I had to track the wires electrically because the schematic and what's actually on the boat do not add up... Here's the schematic:
According to the yellow highlighted area the wiring is for a straight 120 volt setup... Terminal block 10DTB/120 (highlighted in red) receives power from from the generator... In the schematic the terminal block is shown horizontally with the top side receiving the power... In practice the terminal block is vertical with the left side receiving the power... And what's there is as follows (from top to bottom):
- Black with red stripe wire: presumed to be Line 1
- Black wire: presumed to beLine 2
- White: presumed to be Neutral (common)
- Green: presumed to be Ground (common)
- Black with red stripe wire: not used
- Black wire: 2 red wires, one connected to the "A/C" selector (off, shore, generator) switch and the other one connected to the “house” selector (off, shore, generator) switch in the panel
- White wire: 2 white wires, one connected to the "A/C" selector (off, shore, generator) switch and the other one connected to the “house” selector (off, shore, generator) switch in the panel
- Green wire: connected to ground strip in the panel
Basically what I’m thinking is the following change (blue text) to the right side of the 10DTB/120 terminal block:
- Black with red stripe wire: (a.k.a. line 1) connected to the "A/C" selector (off, shore, generator) switch in the panel
- Black wire: (a.k.a. line 2) connected to the “house” selector (off, shore, generator) switch in the in the panel
- White wire: 2 white wires, one leading to the "A/C" selector (off, shore, generator) switch and the other one leading to the “house” selector (off, shore, generator) switch in the panel
- Green wire: connected to ground strip in the panel