Page 1 of 1
Just bought 1986 bertram 28
Posted: Jan 2nd, '12, 18:34
by bertram 20
i just bought my self a new to me boat wanted some suggestions on getting old fuel tank out ?I am not taking any chances with old one.The tank in this boat is massive 245gallons thanks for any ideas.
Posted: Jan 2nd, '12, 18:46
by In Memory Walter K
Is that a 28 Bahia Mar? Gas Inboards with shafts? That 245 gallon tank is fiberglass? I didn't think that size tank was standard for that boat. Is the deck removable? Fiberglass or Nautilux covered plywood like the B-31's were?
Posted: Jan 2nd, '12, 18:49
by bertram 20
no not a 28 bahiamar 28 FBC with fiberglass tank still
Posted: Jan 2nd, '12, 19:44
by BCBertie
The rear deck comes out pretty easy (well, it did on mine!). I've heard the the FBCII tank was anywhere from about 230 gallons on up to 265. They are held in with the typical Bertram blob of resin and occasionally tabbed to the stringers.
Poly-u-mac makes all three of the B28 tanks (they are the source of tanks for both Bertram and High Tide)...
http://www.polyumac.com/Tanks.html#
Good luck!
John
Posted: Jan 2nd, '12, 19:58
by Bob H.
Bert 20, My tank came out the hard way...cut all tabs holding it down, most likely foamed in place, put lifting tension on the factory lift points, I used a mini excavator and had the back of the hull lifted off the stands..i then made some wedges and drove them in from both ends until it gave up and popped free..have fun...BH