glendenning controls

[Russ Pagels]

Has any one Installed/used the Glendenning single lever controls?Good,bad, use or stay away from them. thanks Russ

[Bruce]

I have installed numerous EEC3 pure electronic controls with no issues.

If your talking about the electronic to the cable actuator boxes then I haven't used them.

GD products to me have all been good with few issues. Certainly much better than the micro commanders or twin disc setups.

I used one of the first electronic setups and sync system on a (31)Cummins QSB when they first came out. It was apparently either a prototype or a trial setup because it came with no instructions for install or setup and I had to figure it out but it all worked together fine.

I have some under the dash pics of the single lever thru the side console installs if you want to see on a 31.

[Russ Pagels]

Bruce, thanks for the come back. Yes I would like to see the pictures when you get a chance. thnaks again....Russ

[Bruce]

Control arm from outside:



Control from under the dash:



Sync unit center, the rest are the QSB boxes and wiring:

[Russ Pagels]

Thanks Bruce, these pictures will be a great help. Russ