Page 1 of 1
Adding a control on the engine box
Posted: Jul 29th, '09, 20:12
by Ironman
Ive got Morse elec. controls.. 2 station now.The tower & the bridge.... the boxes have four pigtails off them to have up to four stations.. Ive recently added the harness wires ,& today I tried to operate the controls after hooking up the third station... I have no book but it seems to need a programming session?Wont light up.
Anyone have these or had this problem
Wayne
Posted: Jul 30th, '09, 17:36
by Ironman
Got it... Problem was. I had the boat rewired. The battery switch" USED TO"shut off everything cept the bilge pumps.So when I tried to reset the controls..
. Now the battery switch is not off when plugged into the dockside power.. Im on a mooring most of the time so I didnt notice that till today.. Last night I unplugged the power . Today I tested & the controls work.. DUH
Wayne
Posted: Jul 31st, '09, 10:21
by Rawleigh
That will be a nice addition.
Posted: Aug 1st, '09, 09:56
by Capt Dick Dean
From past postings there were statments as to how you keep the bilge dry. Have you come across a better method than a sponge?
Courious deranged minds want to know.
Posted: Aug 1st, '09, 19:34
by Ironman
Was nice for a while....Im not sponging lately... I have a leaky rudder.. cant keep up.. Getting over it.
Wayne