Page 1 of 1
Bilge Pump Installation
Posted: Mar 11th, '09, 22:23
by Tony Meola
I am going to install a third bilge pump between the engines right behind the cabin bulkhead and I was wondering what is the best material to use as a mounting base?
I really don't want to use plywood. I was wondering what everyone has used for a block.
Posted: Mar 12th, '09, 05:10
by CaptPatrick
Tony,
I cut a piece of fiberglass plate to match the diameter of the pump base and epoxy it to the hull.
Posted: Mar 12th, '09, 20:27
by Tony Meola
Capt. Pat
Thanks. I have some fiberglass left over from the repower, I will cut a piece of that up and epoxy it down.
Posted: Mar 12th, '09, 20:43
by gplume
Also thanks...its on my list of things to do this year.
Posted: Mar 13th, '09, 09:45
by Bertramp
amazing how some simple things, when you see them done really RIGHT ... look GREAT !!