Page 1 of 1
little progress
Posted: May 21st, '08, 17:13
by 1962 31
all the deck supports are in and got the deck all shaped up
[/img]
[/img]
[/img]
Posted: May 21st, '08, 19:48
by mike ohlstein
Nice looking lumber.
You might consider hatches in the center panel over the stern bilge pump, and the forward fuel cock.
Posted: May 21st, '08, 20:31
by Tony Meola
Tom
Moving along nicely. Looks a lot different than before. Did you close the deal on the new shop?
Posted: May 21st, '08, 21:07
by In Memory of Vicroy
Ditto what the Prof said, make more and bigger hatches, you will thank us some day when you need to get at the stuff that makes her go "zoom" vs. a dock boat like the Timmy Pot Plant Boat.
UV
Posted: May 22nd, '08, 08:12
by jspiezio
mike ohlstein wrote:Nice looking lumber.
You might consider hatches in the center panel over the stern bilge pump, and the forward fuel cock.
Take that advice, just my $.02.
It looks really good, and moving unbelievably fast
Posted: May 22nd, '08, 17:13
by 1962 31
i cut the hatch in the center piece today it was just a mock up yesterday and got the center all glassed up
Posted: May 23rd, '08, 06:55
by Brewster Minton
Just a stupid question. Are you going to replace those rudder shelves?
Posted: May 23rd, '08, 08:05
by 1962 31
why u don't think they will hold up
just kidding they will be next i just want to get the deck done but not permanently installed before i rip any thing else out
after the shelves it will be the strut backing and then keep going from there
Posted: May 23rd, '08, 08:45
by Brewster Minton
Thats what I thought you were going to do. Sorry just checking. Keep at it and it will be worth it in the end.