Page 1 of 1
315 Yanmar ?
Posted: Oct 21st, '07, 16:50
by JohnCranston
What series Raycor's do I need for these engines?
Thanks in advance.
Posted: Oct 21st, '07, 17:42
by In Memory of Vicroy
900s should do fine.
UV
Posted: Oct 21st, '07, 20:23
by JohnCranston
Thanks UV.
Posted: Oct 22nd, '07, 07:01
by Brewster Minton
Make sure they are in a place were you can change them easy. Filters often need to be changed when conditions are poor (3-5 foot seas). I have seen many times where they have been put in in such a way that you cant get at them except a the dock. My 2 cents.
Posted: Oct 22nd, '07, 08:26
by Mikey
Amen Brewster, Amen.
Seems I promised pictures of my Racor installation. Did I post those or was I dreaming?
Posted: Oct 22nd, '07, 08:46
by ZeroCavity
Reed this article @ BoatDiesel.com
http://boatdiesel.com/index.cfm?&CFApp= ... 3060666437
I did a similar setup.
Posted: Oct 22nd, '07, 14:16
by Rawleigh
I always thought a manifold system would be great so that you could run both engines off one filter during the filter change thereby enabling you to keep headway into a big sea.
By-pass
Posted: Oct 22nd, '07, 17:06
by Capt. Mike Holmes
Rawleigh, or just a bypass on each filter. Running without one while changing an element would probably not cause any harm.