bertram31.com

Well, . . . I took the barring tool and inserted, added a short bar, said a little prayer, threatened to drown the son of a bitch in CW and it turned easily. Weird. So, I reistalled the starter and got the same click click click.
"Damn", I thought, "bad starter." But before I pull that critter off again, think I'll bar it over some more. Did about a full rev and a half and tried the starter again and low and behold, RRRRRRRRR.
WHEW! Even got oil at the valves so we've got oil pressure. Tomorrow I'll start to reassemble and see if I can kill mosquitos behind Dreamsicle.
Thanks, guys for the aid and encouragement. Keep you posted.

Good news for sure. Shoot that starter bendix with CX too. Are you familiar with the fuel bleeding procedure for the 6BTA? Gotta do it by the book or you will never get them started.

UV

Good news Mikey. Looking forward to seeing her out on the Bay.

What a relief ! ! !
Now where can you get such drama and gratification???.........AINT boatin fun! ! ! !

Harry Babb

Gotta do it by the book or you will never get them started.

Listen to our wise uncle, he speaks the truth.

Good job Mikey.

Need a job?

Go Mikey!

Good to hear Mikey! You didn't even need my gallon of CX! Glad you were able to runn down the Snap On guy and try the proper tool before trying anything more drastic!

Here we see it again. This WAS a big problem .. could have been big bucks but thanks to this site, all is going just fine. Yeah, Mikey could have gotten the thing turning on advice from elsewhere.

But he got it here. Long live Captain Patrick!

Amen, Capt Dick, Amen!

Home run Mickey! Glad you got it .Whew ! Dave K