bertram31.com

i lost my gel-kote activater( hardner )... what can i use ???or should i use??

phil

Phil,

MEKP, same as polyester resin, (which is what gelcoat is...). Mix ratio is 3% - 4% depending on ambient temperature.

Br,

Patrick

i figured as much ,but wanted to make shure..you about dried out up there? i am headed home tommorow for a week ,,,,gota bail the front yard,then back to port a . got the boat in the covered shed for awhile...waiting for good weather and the white run in sept,,,,thanks again....

phil

Phil,

Nice & dry up here, only a couple of inches this month...

Br,

Patrick

dry down here also got lucky on the hurricane,,

phil

Also -- use the wax additive if the surface gelcoated is exposed to air. Avoid letting it cure in direct sunlite if possible. Both could lead to a tacky surface. I found using a little extra MEKP for a faster batch is better.

Pretty work.

Phil,

Outstanding job. One almost hates to get fish blood on the deck when they look like yours does.

Dick

Phil : Beutiful Boat !!!! Can you post more photos ? Will like to see your flybridge with more detail.