Page 1 of 1
Getting it Done
Posted: Sep 15th, '16, 22:20
by Keith Poe
Re: Getting it Done
Posted: Sep 15th, '16, 23:22
by Tony Meola
Keith
Nice job. Just make sure the bulkheads are not tabbed tight to the hull above the chine. She needs to flex there or she will crack on you.
Re: Getting it Done
Posted: Sep 16th, '16, 06:02
by John Nardi
Very nice...About 3 months ahead of my project (I Hope) !! Are you going to spray or roll the gelcoat?? Sorry if that is a stupid question...Good luck, John
Re: Getting it Done
Posted: Sep 16th, '16, 08:22
by PeterPalmieri
lookin good Keith
Re: Getting it Done
Posted: Sep 16th, '16, 08:27
by Keith Poe
Thanks guys
I'm going to spray and roll.
I already sprayed everything inside.
I'm going to roll all the none skid and most likely spray the rest.
Re: Getting it Done
Posted: Sep 16th, '16, 10:42
by John F.
You've been busy. She looks good. Nice and solid. Congrats.
Re: Getting it Done
Posted: Sep 19th, '16, 06:30
by Carl
Tony Meola wrote:Keith
Nice job. Just make sure the bulkheads are not tabbed tight to the hull above the chine. She needs to flex there or she will crack on you.
Thought worth mentioning again...thought tabbing of bulkheads to hull is supposed to be gapped to allow some flex. But I am out of my area...just what I understood.
Gotta say, Keith...you do take on projects in a Get'er done fashion.
Can't wait to see the finished video!
Carl