Page 1 of 1
Hynautic question
Posted: Mar 9th, '07, 10:57
by Leigh
I had my H50 Hynautic helm unit on the bridge refurbished. I have reinstalled and am ready to fill and bleed the system per the Hynautic instructions. Question: Do I need to go through the bleed procedure on the lower helm and rudder cylinder if these have been left undisturbed through the process? Any other thoughts on doing this the right way would be appreciated. Thanks, Leigh
Posted: Mar 9th, '07, 12:26
by Peter
Here is a page where you can download bleeding instructions for free. Click on the link below and then click on the title for HYNAUTIC SYSTEMS.pdf
These instructions are no longer available from Teleflex.
Who knows how much longer these instructions will be available here? So once you get 'em think about printing them out and putting them somplace with other important documantation for your boat and equipment.
http://www.seatechmarineproducts.com/_downloads/49
Peter
Hynautic question
Posted: Mar 9th, '07, 12:43
by Leigh
Peter: Thanks. This is a more complete set of instructions than what I have.
Posted: Mar 9th, '07, 22:12
by Kingfish
Thanks for the info Peter, too much knowledge is not enough.