bertram31.com

Has anyone had any experience with phasor marine generators in a bertram 31,
would love the feedback.

WC

Bill Cash,
I don't know of anyone on the board using Phasor Generators, I know a lot guys used Mase gen sets, Northern Lights and Onans. Maybe Bruce will chime in on the subject. Most guys used what fit the best on the outboard side of the port engine.
Pete Fallon

Do you have any photos or know anyone with photos of gensets like onan and northern lights, I have seen Bob Lico's MASE in his boat.

I have the Fischer Panda 4.0 and it fits on port side next to Cummins 6BTA. A little tight but it went in no problem. If you want pics I can send later today. This 1 cylinder diesel unit runs at 3600 RPM but burns no fuel...I think 1/4 gal/hr. and it can run reverse cycle A/C & heat.

I would love to see some photos, i like the panda generators.

Wursty: How is vibration and noise with that single cylinder?

Rawleigh, you know it's not too bad since it's fully enclosed with sound shield. I installed it on rubber pads to reduce the vibration but like most genis you can hear and feel it running but not annoying. Biggest issue is the exhaust is sometime below waterline and this causes a wet transom and bubbling noise only when heavy with fuel.

This is the install of the Fischer Panda 4.0