bertram31.com

Boat left my shop today here is a little slide show...https://www.youtube.com/watch?v=iaf7AAA ... e=youtu.be

Incredible. She looks great.

Perfection... And, as soon as you'll put the power in it will be purrfection :-)

wow another beauty

Boat looks great what cummins engine did you decide on?

Thanks everyone, Bob it's at Forked River Diesel getting Cummins QSB 380's and if that is to much we will de-tune accordantly 355,330 or 305 evidently it's just a few keystrokes on the computer and you dial in your hp

Do you still have the oem shaft logs in the boat and are you open to F/G shaft log and reduced shaft angle to utilize 380hp along with specialize props

Jimmy

A vision of beauty. Best of luck.

bob lico wrote:Do you still have the oem shaft logs in the boat and are you open to F/G shaft log and reduced shaft angle to utilize 380hp along with specialize props

Bob shaft logs are out and the bedding area ground out waiting to glass in tubes, that is as far as I can go until engine angles are established

Really gorgeous!

There is something missing here! You are the one to tell the installer " this is NOT a normal installation you want to slide a nickel under the drain plug of the ZF transmission and that is the total clearance from bilge. You will have to tilt struct with shim to creat new shaft angle.

Nice Job Jimmy!