Page 1 of 1
Bruce need help boost
Posted: Feb 2nd, '07, 10:44
by Brewster Minton
Bruce I was hoping you would know. I got the boost guages they go up to 30psi is that high enough for the Yanmar lp6s 315 I was told they develope 32-36psi is this true? I did not see any vdo boost guages that went higher than 30 psi.
Posted: Feb 3rd, '07, 09:29
by Brewster Minton
any help from anyone would be great
Posted: Feb 3rd, '07, 12:18
by scot
Sorry Brewster don't know "jack-squat" about Yannies.
Bump..
Posted: Feb 3rd, '07, 15:15
by Bruce
Flat out around 32psi. After that the waste gate opens.
30 psi gauges are fine.
Posted: Feb 3rd, '07, 15:26
by CHolgerson
Brewster, Bruce
I bought my father a set of Livorsi boost guages for Christmas and we installed the guages in the panel but have not routed the hoses yet. Where do you hook the boost line up on the motor? We also have the yanmar 6LP.
Posted: Feb 3rd, '07, 17:25
by Bruce
Remove the boost pressure sender and connect there.
Posted: Feb 3rd, '07, 18:13
by Brewster Minton
Bruce thank you