Back bulkhed

[NV3167]

I am trying to find out the best solution to replacing the L-Beam aluminum that is along the top of my back bulk head. It actually holds the back bulkhead to the bridge.

I tried to go to a fab shop to have them make one, but they said they could not make the bend.

Any suggestions?

[Rawleigh]

How about fabricating it out of two pieces of plate and having it welded together to form the angle? Any good metal fabricator should be able to bend it. I don't recall it being that complex, but I could be wrong.

[thereheis]

i took my L piece out and glassed in the bulkkhead...inside and out...all the screws were loose and it was just hanging there,,looks alot better glassed in also..my 2-cents worth.i still have the old one...

phil