rear deck is going back in after new tank

The Main Sand Box for bertram31.com

Moderators: CaptPatrick, mike ohlstein, Bruce

Post Reply
User avatar
scenarioL113
Senior Member
Posts: 690
Joined: May 31st, '08, 09:00
Location: Massapequa Park, NY

rear deck is going back in after new tank

Post by scenarioL113 »

I was wondering what may be used to seal the rear deck when I lay it back down. There is a material that is very similar to 5200 or 4200 that was used previous. I am pretty positive whatever was used was put there when the boat was built new.

What would be something to seal her up with?


On another note I still have some of the old material that I am having trouble removing, any tips or trick on getting it to peel off from the cockpit?
1971 28 Bertram
4BT Cummins

Frank

9-11-01 NEVER FORGET
User avatar
Bruce
Site Admin
Posts: 3789
Joined: Jun 29th, '06, 12:04
Location: Palm Beach Gardens, Fl.

Post by Bruce »

If your talking the seams between deck panels, I've always used white silicon.
steve miller
Senior Member
Posts: 157
Joined: Aug 29th, '06, 21:40
Location: block Island R.I.
Contact:

Post by steve miller »

A silicone follow up....... I spoke with the G.E.people when I bought some silicone that wouldn't cure (turned out it had been heated above 80 degrees; who knew?) they told me silicone was silicone. That whether you buy marine, door & window, bath, whatever...the silicone is the same. What do you know about this, Bruce?
User avatar
Carl
Senior Member
Posts: 6082
Joined: Jul 5th, '06, 06:45
Location: Staten Island NY

Post by Carl »

You don't want to use 5200. That is an adhesive and a real good one at that.

Aside from 5200 not liking the UV rays from sunlight...if you ever need to pull up the deck again you will be in for a real treat...NOT.

You just want to create a seal.
User avatar
TailhookTom
Senior Member
Posts: 985
Joined: Jul 3rd, '06, 14:12

Post by TailhookTom »

If you need the best stuff to remove any adhesive sealant I highly recommend AntiBond -- I was dropping the struts on my former B31 to press new cutlass bearings in and 5200 held them in place without the bolts. I gave a good soak with AntiBond and I pulled them right off with little effort.
User avatar
In Memory of Vicroy
Senior Member
Posts: 2340
Joined: Jun 29th, '06, 09:19
Location: Baton Rouge, LA

Post by In Memory of Vicroy »

I'm aboard with the "silicone is silicone" deal. I have started using some stuff called "Kwik Seal" by DAP from the hardware store that is cheap, easy to use, and dries to a nice bright white that does not seem to yellow in sunlight. And once you open the tube the left-overs don't harden like most 3M stuff does. It is advertised as an "adhesive sealant" for kitchen and bath uses and seems to be somewhere between 3M 101 and 4200. Not for use below the waterline, but a really nice product, and the lack of "marine" on the label makes it a helluva bargain.

UV
Post Reply

Who is online

Users browsing this forum: No registered users and 198 guests