Bertram 28

[Jrssndb1]

Rebuilding 1979 28, boat has mercy 228hp engines, the carb intake wedges appear to be missing. Did this application come with wedges?, where might I find them, nla.

[Donmystic1]

What is the down angle of the engine. I have a 1986 and no wedges.

[Jrssndb1]

It appears to be 15 degrees

[Donmystic1]

I don’t think that you need wedges for that little angle. See what others say about your vintage boat and engines

[Captmas]

Ours is a 76’ Bert 28 with the same motors and it does have wedges ....you may find them at Summit Racing
Mike

[Jrssndb1]

Thanks everyone for the info!!

[bertram 20]

i have a 1986 28 FBC with twin merc 350s and both engines have wedge plates under carbs i recently put edelbrock carbs which i love and was looking for a spare set of wedge plates to modify because the edelbrock would not work properly with out opening up center of wedge plate i did find a pair at some boat junk yard and they were the proper angle degree so i have a set for rochester carbs and the ones i modified for the edelbrocks