bertram31.com

All good advice from knowlegeabls folks - much appreciated and I'll keep you all posted on the results.

Thanks again for great advice - what makes this group so special.

Anybody have any suggestion where to begin troubleshooting this problem? Starting batteries are good, port engine turns over and starts fine however starboard engine will turn over when plugs are pulled (and occaisionally when plugs are installed ) when the starter switch is turned on, you can hear ...

I had my "mandatory" 5 year insurance C&V survey done last spring on my 1978 B28 - A very thorough and complete survey by a professional surveyor - the vessel has been "fished hard" and "left wet" throughout its lifetime yet the surveyor completed the survey and said "it's bulletproof" - no deck or ...

Makes you think...would you rather spend your time and money on a 30+ year old "real bertram" hull or go with the 2009 model....

I'm in

"tesseract" - B28

Anyone have recommendations for a reputable tank removal/installation firm for a B28 in the Massachusetts area?

Many thanks.

Anyone have experience/recommendations for a gas tank installer in the Massachusetts area?

Thanks.

Mark, I have a 1978 B28 with Chevy 305's - 17X16 props, Bimini full enclosure, Radar arch and way too much gear - I run 3100-3200 rpm at 20-21 kn @ 1 nm per gal. - Mine seems to run easier slightly over 3000 rpm - boat stays up on her strakes and engines sound smother. I've cruised at these rpm's fo...

Got mine today - Thanks again for taking on this task - well done

I'm in - 2 long sleve XL and 2 short sleve XL.

Let me know where to send check and cost.

Thanks

Thanks all for the advice - I'll let you know how the project progresses. On another issue - launched with the gate valves closed to the raw water strainers - opened them up then started both engines - both quickly pegged the engine temp guages - shut them down and let the engines cool, then restart...

Hello all - Looking for some advice on installing FloScans - Instructions say install sensor at lowest point of fuel line, after fuel filters - since I have carburated inboards, Flo Scan instructions requires pulsator installed at least 12 inches from sensor and at least 2" rise between those units....