Hynautic question

Leigh · Post by **Leigh** » Mar 9th, '07, 10:57

I had my H50 Hynautic helm unit on the bridge refurbished. I have reinstalled and am ready to fill and bleed the system per the Hynautic instructions. Question: Do I need to go through the bleed procedure on the lower helm and rudder cylinder if these have been left undisturbed through the process? Any other thoughts on doing this the right way would be appreciated. Thanks, Leigh

Peter · Post by **Peter** » Mar 9th, '07, 12:26

Here is a page where you can download bleeding instructions for free. Click on the link below and then click on the title for HYNAUTIC SYSTEMS.pdf

These instructions are no longer available from Teleflex.
Who knows how much longer these instructions will be available here? So once you get 'em think about printing them out and putting them somplace with other important documantation for your boat and equipment.

http://www.seatechmarineproducts.com/_downloads/49

Peter

Leigh · Post by **Leigh** » Mar 9th, '07, 12:43

Peter: Thanks. This is a more complete set of instructions than what I have.

Kingfish · Post by **Kingfish** » Mar 9th, '07, 22:12

Thanks for the info Peter, too much knowledge is not enough.

bertram31.com